PRS 4 Pot Vintage Wiring Harness

£65.50 – £71.50

We build your PRS 4 Pot Vintage Wiring Harness to order using professional fully tested electrical components.

Includes wiring diagram & installation guide.

Description

PRS 4 Pot Vintage Wiring Harness with Coil Split Option

This pre-wired PRS 4 Pot Vintage Wiring Harness is designed for replacing old electrics or upgrading the electronics of imported models or for use on DIY Kits. We take a massive amount of care and attention when putting our PRS 4 Pot Vintage Wiring Harnesses together. Everything is fully tested before being posted to you.

This is a Professional PRS wiring harness using the very best in components to enhance the quality of tone and sound output from your guitar.

Read about our Vintage Wiring Harnesses Here. We use our PRS 4 Pot vintage wiring harnesses in our workshop for our clients guitar upgrades and also for our Axeify guitar upgrading services, read more Here.

Components
Premium 500k CTS Potentiometers x 4, split shafts with vintage audio taper and coil splitting option
Capacitor x 2, Size 0.022uF / Sprague Orange Drop.
20AWG Tinned copper ground.
Pots supplied with Nut, Flat Washer & Locking Star Washer.
You are welcome to Contact Us with your custom requirements.

Controls – You can have the Push & Pull pots on either the Volume or tone pots.
Volume 1 – Bridge.
Volume 2 – Neck.
Tone 1 – Bridge / Push & Pull for Pickup Coil Split.
Tone 2 – Neck / Push & Pull for Pickup Coil Split.
Or… (Please choose when ordering)
Volume 1 – Bridge / Push & Pull for Pickup Coil Split.
Volume 2 – Neck / Push & Pull for Pickup Coil Split.
Tone 1 – Bridge.
Tone 2 – Neck.

Will this fit my guitar?
Our pre-wired PRS Wiring harness is wired to fit all genuine PRS models. If installing into an imported model or a DIY guitar kit you will need to ensure the Potentiometer holes will take CTS pots (approx 10mm). This can be done using a round file or carefully with a 10mm drill.

Centre to centre measurements between components
Centre of neck volume pot and neck tone pot – 65mm.
Centre of neck volume pot and bridge volume pot – 50mm.
Centre of neck tone pot and bridge tone pot – 50mm.
Centre of bridge volume pot and bridge tone pot – 65mm.
Measurements can sometimes vary slightly on some PRS models, so we allow plenty of movement in wire lengths between components to allow for a comfortable fit. If your measurements are different from the above, please let us know and we will build your harness to your specifications.

Installation, Documents & Support
Please see our Support Page for wiring diagrams and fitting instructions.
We have made it as simple as possible to install your PRS 4 Pot Coil Split Push & Pull Wiring Harness. We also offer full support should you need it.

Order Times
We make everything to order and the turnaround time for a PRS 4 Pot Coil Split Push & Pull Wiring Harness is 48 hours.

You may also need the following to complete this Wiring Harness: