Gibson & Epiphone Explorer Vintage Wiring Harness with Coil Split

£66.50

We build your Gibson & Epiphone Explorer Coil Split Push & Pull Vintage Style Wiring Harness to order using professional fully tested electrical components.

Includes wiring diagram & installation guide.

Description

Gibson & Epiphone Explorer Coil Split Push & Pull Wiring Harness

This pre-wired Gibson & Epiphone Explorer Coil Split Push & Pull Vintage Style Wiring Harness is designed for replacing old electrics or upgrading the electronics of imported models or for use on DIY Kits. We take a massive amount of care and attention when putting our Gibson & Epiphone Explorer Coil Split Push & Pull harnesses together. Everything is fully tested before being posted to you.

This is a Professional Explorer wiring harness using the very best in components to enhance the quality of tone and sound output from your guitar.

Read about our Vintage Wiring Harnesses Here. We use our Explorer Coil Split Push & Pull vintage wiring harnesses in our workshop for our clients guitar upgrades and also for our Axeify guitar upgrading services, read more Here.

Components
Premium 500k CTS Potentiometers x 1, short split shaft with vintage audio taper.
Push & Pull 500k CTS Pots x 2 short split shafts.
Capacitor x 1, Size 0.022uF / Sprague Orange Drop.
Switchcraft USA Jack Socket.
Gavitt USA made Braided wire.
20AWG Tinned copper ground.
Jack Socket and Pots supplied with Nut, Flat Washer & Locking Star Washer.
You are welcome to Contact Us with your custom requirements.

Controls
Volume 1 – Bridge / Push & Pull for Pickup Coil Split.
Volume 2 – Neck / Push & Pull for Pickup Coil Split.
Master Tone

Will this fit my guitar?
Our pre-wired Explorer Wiring harness is wired to fit genuine Gibson & Epiphone models. If installing into an imported model / DIY guitar kit you will need to ensure the Potentiometer holes will take CTS pots (approx 10mm). This can be done using a round file or carefully with a 10mm drill.

Centre to centre measurements between components
Pot Spacing is normally 60mm apart – centre to centre
When ordering, please email us the distance (centre to centre) of the 3 pots on your Explorer. There are several variations of the Explorer pots spacing. We allow plenty of movement in wire lengths between components to allow for a comfortable fit.

Installation, Documents & Support
Please see our Support Page for wiring diagrams and fitting instructions.
We have made it as simple as possible to install your Gibson & Epiphone Explorer Coil Split Push & Pull Vintage Wiring Harness with a fitting guide and simple to follow wiring diagram. We also offer full support should you need it.

Order Times
We make everything to order and the turnaround time for a Gibson & Epiphone Explorer Coil Split Push & Pull Vintage Wiring Harness is 48 hours.