Fender Telecaster Vintage Wiring Kit with 3 Way Switch

Description

Fender Telecaster Vintage Style Wiring Kit with 3 Way Switch

To fit single coil x 2 pickup models (traditional)

This Fender Telecaster Vintage Wiring Kit with 3 Way Switch is designed for replacing old electrics or upgrading the electronics of imported models or for use on DIY Kits. We take a massive amount of care and attention when putting our Fender Telecaster Kits together. Everything is fully tested before being posted to you.

This is a Professional Telecaster Wiring Kit using the very best in components to enhance the quality of tone and sound output from your guitar.

Components
Premium 250k CTS Potentiometers x 2 – Solid Shaft.
CRL Vintage USA 3-way switch.
Switchcraft Jack Socket.
Sprague Orange Drop Capacitor, Size 0.047uF.
Tinned-copper “buss” ground wire.
Gavitt USA cloth covered 22AWG wire.
Heat Shrink Tubing.
Jack Socket and Pots supplied with Nut, Flat Washer & Locking Star Washer.
You are welcome to Contact Us with your custom requirements.

Treble Bleed Option
A Treble Bleed takes the high treble tone frequencies out of the circuit at the volume pot and puts them back in the circuit as the signal leaves the volume pot. The result is a smoothed out treble and a more uniform tone from 1 to 10. Reducing the treble drop out as the volume pot rolls off. If you like the idea of retaining treble as you roll your volume pot down, then a treble bleed is for you.

Controls
Master Volume Control.
Master Tone Control.

Switching
Position 1 – Bridge Pickup.
Position 2 – Bridge & Neck Pickup.
Position 3 – Neck Pickup.

Will this fit my guitar?
Our Fender Telecaster Vintage Wiring Kit is designed to fit genuine Fender USA or Mexican control plates. If installing into an imported model, you will need to ensure the Potentiometer holes on the control plate will take CTS pots (approx 10mm). This can be done using a round file or carefully with a 10mm drill.

Installation, Wiring Diagram and Support
Please see our Support Page for wiring diagrams and fitting instructions.
We have made it as simple as possible to install your Fender Telecaster Vintage Wiring Kit with 3 Way Switch with a fitting guide and simple to follow wiring diagram.
We also offer full support should you need it.

Order Times
The turnaround time for a Fender Telecaster Vintage Wiring Kit with 3 Way Switch is 48 hours.

Fender Telecaster Vintage Style Wiring Harness with 3 Way Switch