Gibson & Epiphone Les Paul Jimmy Page Wiring Harness

Description

Gibson & Epiphone Les Paul Jimmy Page, Coil Split, Out of Phase, In Series Wiring Harness

The wiring harness features 4 CTS Push n Pull Pots which provide choices of Coil Tapping, Phase Switching and In Series for functional and versatile sonic variety.

Delivers a “21 Tone” Salute to one of the greatest guitarist of all time.

This pre-wired Gibson & Epiphone Les Paul Jimmy Page Wiring Harness with 4 x Push & Pull Pots is designed for replacing old electrics or upgrading the electronics of imported models or for use on DIY Kits. We take a massive amount of care and attention when putting our Gibson & Epiphone Les Paul Jimmy Page Harnesses together. Everything is fully tested before being posted to you.

This is a Professional Les Paul Jimmy Page Wiring Harness using the very best in components to enhance the quality of tone and sound output from your guitar.

Components
USA 500k CTS Push & Pull Potentiometers x 4, Short or Long Split Shaft (fitted with additional nut for height adjustment on the long shaft pot).
Sprague Orange Drop Capacitors x 2, Size 0.022uF.
Tinned Copper “Buss” Ground Wire.
Mounted on a 3D Printed Wiring Template.
Pots supplied with Nut, Flat Washer & Locking Star Washer.
You are welcome to Contact Us with your custom requirements.

Long or Short Potentiometers? (Pots)
If you are unsure of the pot length required on your Les Paul Jimmy Page Guitar, then please order the Long Pots as they will fit all models and can also be adjusted in length due to the extra nut fitted, where if you order the Short Pots they may not be long enough.
Short Pot threaded bushing height: 9.52mm.
Long Pot threaded bushing height: 19.05mm (supplied with 2 nuts for height adjustment).

Push n Pull Pots Configuration
All Push Pulls in Down Position – Standard Les Paul Wiring.
Neck Volume Up – Splits Neck Humbucker to Single Coil.
Bridge Volume Up – Splits Bridge Humbucker to Single Coil.
Neck Tone Up – Bridge and Neck Humbuckers In Series Together.
Bridge Tone Up – Neck and Bridge Humbuckers Out of Phase.

Will this fit my guitar?
Our pre-wired Les Paul Classic Wiring harness is wired to fit all genuine Gibson & Epiphone Jimmy Page models. If installing into an imported model or a DIY guitar kit you will need to ensure the Potentiometer holes will take CTS pots (approx 10mm). This can be done using a round file or carefully with a 10mm drill.

Centre to centre measurements between components
Centre of neck volume pot and neck tone pot – 63mm.
Centre of neck volume pot and bridge volume pot – 50mm.
Centre of neck tone pot and bridge tone pot – 50mm.
Centre of bridge volume pot and bridge tone pot – 61mm.
Measurements can sometimes vary slightly on some Les Paul Jimmy Page Models, so we allow plenty of movement in wire lengths between components to allow for a comfortable fit. If your measurements are different from the above, please let us know and we will build your harness to your specifications.

Installation, Wiring Diagram and Support
Please see our Support Page for wiring diagrams and fitting instructions.
We have made it as simple as possible to install your Gibson & Epiphone Les Paul Jimmy Page Wiring Harness. We also offer full support should you need it.

Order Times
We make everything to order and the turnaround time for a Gibson & Epiphone Les Paul Jimmy Page Wiring Harness is 48 hours.

Gibson & Epiphone Les Paul Jimmy Page Wiring Harness